Tools
Solenoid Valve
Narrow Your Results
Mfr / Trade Name
Valves, Drop Tubes & Vents
Type
Composition
Size
Pressure Differential
Voltage
- List View
- Gallery View
| Page of 1 |
Overfill Prevention Valve Drill Fixture Tool A1100
Item No. 566675
Aligns holes for drilling to ensure vapor-tight seal
1 Inch Solenoid Valve Viton Seal 120 Volt/60 Hz Ac Coil
Item No. 710-01001V
Installed on piping leading from an aboveground tank to prevent accidental siphoning
1-1/2 Inch Solenoid Valve Viton Seal 120 Volt
Item No. 710-01501V
Installed on piping leading from an aboveground tank to prevent accidental siphoning
2 Inch Solenoid Valve Viton Seal 120 Volt Explosion Proof
Item No. 710-02001V
Installed on piping leading from an aboveground tank to prevent accidental siphoning
3 Inch Solenoid Valve Viton Seal 120 Volt/60 Hz Volt Ac Coil
Item No. 710-03001V
Installed on piping leading from an aboveground tank to prevent accidental siphoning
1-1/2 Inch Solenoid Valve Stainless Steel Teflon With 120 Volt/60 Hz Ac Coil
Item No. 710SS-21501V
Installed on piping leading from an aboveground tank to prevent accidental siphoning
2 Inch Solenoid Valve Stainless Steel Teflon With 120 Volt/60 Hz Ac Coil
Item No. 710SS-22001V
Installed on piping leading from an aboveground tank to prevent accidental siphoning
Fill/Vapor Adapter Wrench Complete With Cross-Bar, Shaft, And Bit
Item No. A0081-001
Use to install and remove EMCO Fill and Vapor Adapters with octagonal bases and the 494096 Riser Seal.
3/4 Inch Solenoid Valve Viton Seal 24 Volt Dc Coil
Item No. 71024D00751V
- Contact sales for valves with any of the following coil options: 12, 24, 120, 208, 240, and 480 volt AC available; 12, 120 volts DC may be available too
Swivel Wrench For 61SA Fill And 61VSA Vapor Adaptors
Item No. 61SA-TOOL
The 61SA-TOOL is a wrench designed to thread on the 61SA Fill and 61VSA vapor Adapters. The OPW 61SA-TOOL Adapter installation tool is required to insure proper installation of OPW rotatable swivel Adapters thread-on spill containers fill and vapor Adapters TC-400 torque cap for pipe nipples and threaded riser Adapters as per EVR requirements. The 61SA-TOOL includes provisions for the use of a torque wrench to facilitate accurate installation and testing
1-1/2 Inch And 2 Inch Extractor Wrench Tool
Item No. 89-0044
The OPW 89 Extractor Wrench is designed to install or remove OPW 53VML and 30MV Ball Float Vent Valves or OPW 233VP and 233VMP Test Plugs in OPW 233, 233V, and 233VM Extractor Fittings
