BIR Protocal
Assist
Narrow Your Results
Mfr / Trade Name
Category - Main
DIM Installation Kit & DIM Installed Modules
ISD
Submersible Pumps, Motors & Leak Detectors
Type
Composition
Size
Riser Length
Length
Horse Power
Application
- List View
- Gallery View
| Page of 1 |
Line Contactor Relay Older Pre 6-1995 For 1/3 And 1/2 HP Control Box
Item No. 079-425-1
Repair part for Red Jacket "Standard" submersible turbines
20 Foot Plug And Lead Harness
Item No. 144-091-5
Isolates and protects individual dispensers from wiring shorts or phasing issues
20 Foot Plug And Lead Harness Standard And Quantum AG
Item No. 144-162-5
Isolates and protects individual dispensers from wiring shorts or phasing issues
Bir Protocol Dim Dispenser Interface Module For Tls-350R Spare Replacement
Item No. 330280-001-SPARE
Refer to POS Application Guide. If using an ANDI controller, a BIR Protocol DIM is used every time.
120 VOlt IQ Control Box
Item No. 880-051-1
Easy to use and easy to install control for manifold pumps
2 HP AG Variable Speed 90 Inch-151 Inch Intelligent Submersible Turbine Pump With MagShell Without Riser (ISTMR2-00)
Item No. 402731901
Variable speed variable length (90 - 151 inches) with MagShell motor. Includes standard model check valve (40 psi relief / 35 psi reset for MLD and TS-LS300)
Standard Control Box With 115 Volt AC Coil For 1/3 HP, 3/4 HP, 1-1/2 HP, And 2 HP Motors
Item No. 880-041-5
For opening all standard 3/4 inch and 2 inch drum closures and plugs
Conduit Junction Box
Item No. 108-496-5
Conduit junction box - single opening, 2 wire, 2 inch NPT
2 HP Variable Speed 90 Inch-151 Inch Variable Length Submersible Turbine Pump Non-Magshell Without Riser (STPVS2-VL2-00)
Item No. 400834901
Variable length adjusts from 90 inches to 151 inches
2 hp AG Variable Speed 90 Inch-151 Inch Intelligent Submersible Turbine Pump Non-MagShell With Model R Check Valve Without Riser (ISTR2-00)
Item No. 402205901
Variable speed variable length (90 - 151 inches) with non-MagShell motor. Includes model R check valve (24 psi relief / 22 psi reset for PLLD)
