1-1/2 Inch
Aboveground Storage Tank Equipment
Narrow Your Results
Mfr / Trade Name
Category - Main
Manholes & Spill Containers
Caps & Adapters
Containment Sumps, Monitoring Wells & Flex Connectors
Submersible Pumps, Motors & Leak Detectors
Valves, Drop Tubes & Vents
Accessory
Type
Composition
Size
Fuel Type
Length
Gallon Size
Color
Application
Pressure Differential
Voltage
- List View
- Gallery View
Page of 5 |
4 Inch Grey EVR Duratuff Top-Seal Fill Cap (E85 Approved)
Item No. 634TT-7085-EVR
Tight fill top seal cap is installed on top seal Adapters
4 Inch Probe Cap With 3/8 Inch Grommet
Item No. 116M-0375
Drilled and tapped to accept 3/8 Inch wire grommet to secure an electronic tang gauge probe in a tank riser pipe
1-1/2 Inch Threaded Double Outlet Vent Female NPT
Item No. 155-0400AV
Aluminum t-style vent used primarily on small fuel oil storage tanks
1-1/2 Inch Anti-Syphon Valve 5 To 10 Foot Head Pressure
Item No. 199ASV-2150
Factory-adjusted hydrostatic head pressure settings
1 1/2 Inch Buna Union Check Valve With Screen
Item No. 200AS-15
Easily inserted onto existing union fittings in suction systems
1-1/2 Inch Full Port Two-Way Ball Valve
Item No. 21BV-0150
Used throughout fueling systems where a shut-off point is desirable to isolate a section of the piping system
1-1/2 Inch Open Vent Upward Aluminum
Item No. 23-0044
Installed on the top of vent pipes from underground or aboveground fuel storage tanks always open to the atmosphere to allow any pressure or vacuum in the tank to vent
1-1/2 Inch Swing Check Valve - Threaded Brass
Item No. 246A-0100AV
Designed to prevent backflow in horizontal piping systems. Swing check valve allow liquid to flow in a single direction
4 Inch Tight Fill Adapter- Top Seal Without Lugs- Carb EVR Approved
Item No. 305-0200AAEVR
Top seal Adapters thread onto underground and aboveground storage tank fill ports and riser pipes where tight fill connections are required
4 Inch Brass Top Seal Tight Fill Adapter With Lugs
Item No. 305L-0200AA
EVR Approved used for fill ports and access to leak detection on fuel storage tanks
Aluminum 4 Inch Tank Monitor Cap With 3/8 Inch, EVR Approved
Item No. 305XP-0100ACEVR
Aluminum 4 inch threaded port hole 3/8 inch, 2 pound
4 Inch EVR Approved Tank Monitor Cap With 1/2 Inch Threaded Porthole And Cable Connector
Item No. 305XP-1200ACEVR
Used for fill ports and access to leak detection on fuel storage tanks
Replacement 4 Inch Gasket For 305C Series Cap
Item No. 305XPU-01052G
Used to replace missing or damaged gaskets on the 305c series caps
1-1/2 Inch Single Poppet Foot Valve
Item No. 334-0300AV
Installed at the inlet of a suction line bottom of the storage tank
1-1/2 Inch Double Poppet Foot Valve
Item No. 335A-0100AV
Installed at the inlet of a suction line normally at the bottom of the storage tank as a prime holding valve.
4 Inch Updraft Vent
Item No. 354-0400AV
Open vent design used on under ground and above ground tanks
4 Inch NPT Male x 4 Inch x 0.188 Inch Black Steel Submersible Pump Riser Pipe Nipple
Item No. 404RISER
0.188 wall thickness to accommodate submersible pump installation.
4 Inch Side Seal Cap
Item No. 405C-0100AC
Used for fill ports and access to leak detection on fuel storage tanks
4 Inch NPT Male x 5 Inch x 0.188 Inch Black Steel Submersible Pump Riser Pipe Nipple
Item No. 405RISER
0.188 wall thickness to accommodate submersible pump installation.